Hot and Cold Temperature Cycling Test Chamber
Hot and cold temperature cycling test chamber is used to test the capability of material structure or composite materials to withstand the continuous environmental changes between extremely high temperature and low temperature during a short period, and therefore understand the chemical changes or physical damages caused by expansion from heat and contraction from cold in the shortest possible time. It is applicable to metals, plastic, rubber, electronics amongst other materials. The test result can be used as a reference or basis for product improvement.
Range of Testing zone
Type A:-40 ℃~+150℃ ( 200℃ is Optional)
Type B:-55℃ ~+150℃ ( 200℃ is Optional )
Type C:-65℃ ~+150℃ ( 200℃ is Optional)
High temperature Range of Testing zone: +60ºC~+150ºC ( 200ºC is Optional);
Exposure Time of High Temperature: +60℃ ~ +150℃ (200℃ is Optional) 30Mins
Exposure Time of Low Temperature : -10℃~Type A:-40℃ / Type B -55℃ / Type C -65℃ 30Mins
Temperature of Heat-Storing Slot / Heating Time
Temperature of Cool-storing Slot / Cooling Time
RT~-75℃/ About 100mins
Recovery Time / Conversion Time
Material of the inner box is SUS 304# stainless steel,of the outer box is stainless steel or see cold-rolled steel with paint coated.
High temperature resistant , high density , formate chlorine , ethyl acetum foam insulation materials
P.I.D+S.S.R+ Micro-computer balanced temperature control system
Semi-hermetic double-stage compressor(water-cooled type) /Hermetic double-stage compressor (air-cooled type)
Non-fuse breaker, high and low pressure protective switch of the compressor , refrigerator high-pressure protective switch ,
failure warning system, electronic alarm
viewing window(special order)
French 'Tecumseh' Brand, Germany Bizer Brand
AC220V 1∮ 3 lines ,50/60HZ, AC380V 3∮ 5 lines ,50/60HZ
Hot and Cold Temperature Cycling Test Chamber Features:
1.It is divided into three zones: high temperature zone, low temperature zone, and testing zone. The test sample is in static mode.
2.Using touch-control graph control as operation interface, easy to operate.
3.Applying wind route conversation to the shock method to distribute temperature to the testing zone for cold and thermal shock measurement.
4.For high temperature shock or low temperature shock, max. time is up to 999H, and max. circulation cycles are 9999 times.
5.The system can be used for automatic Circulation Shock or manual selective shock.
6.Adopt binary cooling system, with quick cooling effect. Cooling method is water cooling.
7.Can entering normal temperature. RS-232 and RS-485 communication.
Copyright © AI SI LI (China) Test Equipment Co., Ltd. All Rights Reserved | Sitemap